|
|
|
Capture the Screen image on Fanuc for all your procedures and record keeping.
- Insert a PCMCIA /ATA/SRAM card into the slot and Power up the machine.
- Change NC parameter 3301.7 to a 1.
- Change NC parameter 20 to a 4.
- Go to a screen you would like to capture, then press and hold the [SHIFT] button for 5 seconds.
- The control may seem like it locks up for up to 15 seconds. When it frees up an image will be on the card. Please keep in mind some screens may not show up if they are not on the Fanuc side.
|
|
|
|
|
GENERAL DISCLAIMER:
All data on this website is provided without charge or obligation by myself or anyone else who contributes to this site. It is the responsibility of the reader to perform any action outlined here in a safe and responsible manner. The reader assumes all responsibility for service or actions taken as a result of the information contained here. We assume no responsibility for personal or property damage, any type of monetary losses or losses caused directly or indirectly from the material provided in this Web page or any pages contained within the Website. If this site has been translated into another language, we are also not liable for how the site content has been translated.
Click here for full disclaimer and terms
|
HELP US IMPROVE
THIS WEBSITE..!! |
Share with everyone?
...Procedures
...Macro programs
...Experience
...Stories
...Articles
...Recommendations
...Anything related
Suggestions or comments?
Please Email Me: admin@machinetoolhelp.com
Thank you for all your contributions and support.
|
|
|
|
|
